Get Financing Design Yours Build Your Own

Residential Shafted Home Elevators

SHC EZ3 Home Elevator

The SHC EZ3 is the smallest elevator in Staying Home Corporation’s EZ series — a compact, battery-powered home elevator that travels through a simple cutout in the floor, with no elevator shaft, no pit, and no machine room required. The front-entry car measures 33″ wide by 26″ deep with a 76″ ceiling, carries 400 pounds, and reaches up to 14 feet between two landings. Because it runs full-time on its own two batteries — continuously charged from a standard 120-volt household outlet — the EZ3 keeps right on working during a power outage, with enough reserve for ten or more trips in both directions.

SHC EZ3 Home Elevator

The EZ3 was designed specifically to be retrofitted into existing homes with minimal alterations. The integrated sliding door rides with the car, keeping you safely enclosed the whole ride, and the traveling hatch floor covers the opening in the upper floor — it can be finished to match your flooring, so the opening disappears when the car is parked below. Pressure-sensitive top and bottom safety devices stop the elevator if an obstruction is encountered, and a Honeywell residential door interlock, slack cable device, under-car safety pan, and emergency stop and alarm are all standard. Every EZ elevator is built to the ASME A17.1 Section 5.3 residential elevator standard. Prefer a fully enclosed elevator? The same EZ3 can also be installed inside a framed hoistway with automatic controls — up to 3 stops and 21 feet of travel.

Staying Home Corporation builds the EZ series in Harrisonville, Missouri — just south of Kansas City, right inside our own service area — so factory support and parts are never far away. Home Accessibility Solutions is a family-owned dealer, and our installers are licensed elevator mechanics with factory training. The same people who measure your home at the free consultation are the ones who install your EZ3 and service it for years afterward. If floor space is tight, the EZ3 is the one to look at; if you want a deeper car, ask us about the EZ4, and if your floor plan calls for side or pass-through entry, that’s the EZ5 — we install them all and we’ll tell you straight which one fits your home.

Model overview

Why choose the Staying Home EZ3 Elevator

The Staying Home EZ3 is a compact home elevator that travels through a simple cutout in the floor — no shaft, no pit, and no machine room needed. It is the smallest model in Staying Home Corporation’s EZ series, which makes it a natural fit when floor space is tight. The car carries 400 pounds and travels up to 14 feet between two landings. Best of all, it runs full-time on its own two batteries, so it keeps working right through a power outage.

The EZ3 was designed to be retrofitted into existing homes with minimal changes. The standard install is shaftless with two stops, but the same elevator can go inside a framed hoistway with automatic controls for up to three stops and 21 feet of travel. The traveling hatch floor can be finished to match your flooring, so the opening disappears when the car is parked below. Custom powder-coat colors are available, and if the ideal load-bearing wall isn’t there, a semi free-standing package anchors the elevator another way.

No shaft, no pit, no machine room

The EZ3 travels through a plain cutout in the floor — no elevator shaft, no pit, and no machine room. The rough floor opening is 38 3/4 inches by 38 inches, and it works with floor joists running either direction. That is why this model retrofits into existing homes with so few alterations: most of your house stays exactly as it is. See it on the manufacturer’s site →

Keeps running when the power goes out

The EZ3 runs full-time on its own two batteries, which are continuously charged by a 2-amp smart charger plugged into a standard 120-volt household outlet. When a storm knocks out the power, the elevator keeps working — with enough reserve for ten or more trips in both directions. No generator, no special wiring, no getting stranded on the wrong floor.

A drive built with extra strength

The EZ3 rides an extruded aluminum track and is raised and lowered by dual winding cable drums with quarter-inch aircraft cables rated at 7,000 pounds of breaking strength — for a car that carries 400 pounds. A slack cable safety device and limit switches at each stop back the drive up, and the whole elevator is built to the ASME A17.1 Section 5.3 residential standard.

Safety devices come standard

You stay enclosed the whole ride: the sliding car door travels with the car, and a Honeywell residential door interlock keeps it secure. Pressure-sensitive top and bottom safety devices stop the elevator if it meets an obstruction, an under-car safety pan stops the car if something is beneath it, and an emergency stop and alarm are right on the car panel. All of it is standard, not an upgrade.

The opening in the floor disappears

When the car is parked downstairs, a traveling hatch floor covers the opening in the upper floor. It can be finished to match your flooring, so upstairs looks and walks like a normal floor — no open hole, no railing around a gap. Sensors on the hatch cover come standard as part of the safety package.

Covered twice after install

Staying Home Corporation backs the EZ3 with a parts-only limited warranty to the original purchaser: three years on the drive train, two years on other parts, and one year on the batteries. Labor isn’t part of the manufacturer’s warranty — that is where our own 6-month workmanship warranty picks up. If our work wasn’t done right, we come back and fix it at no cost to you.

Family-owned · Wichita, Kansas

From our family to your home

Working with us starts with a free in-home assessment. We measure your space, listen to what you need, and give you a straight answer with a written quote — no pressure. Our installers are licensed elevator mechanics with factory training, and the same people who measure your home install your EZ3 and service it for years afterward. Staying Home builds the EZ series in Harrisonville, Missouri, right inside our service area, so parts and factory support are never far away. Call (316) 361-6220 to get started.

Schedule Our Team Today
Installed in a real home
Capacity400 lbs
TravelUp to 14′, 2 stops
Speed8-10 fpm
PowerBattery — 120 VAC outlet
CodeASME A17.1 Section 5.3
Mfr. Warranty3 yr drive train / 2 yr parts / 1 yr batteries (parts only)

What comes standard

Included on every unit we install — no add-on cost.

Staying Home EZ3 Elevator

What comes standard

  • Integrated sliding car door with clear vision panels — rides with the car
  • Full-time battery power: two batteries with a 2-amp smart charger on a standard 120 VAC outlet
  • Runs 10+ trips in both directions during a power outage
  • Traveling hatch floor — can be finished to match your flooring
  • Fold-down seat
  • Slimline telephone inside the car
  • Carpet on the car floor and floor cutout liner kit
  • RAL 9002 powder-coated finish
  • Constant pressure controls: up/down buttons, key switch, emergency stop, alarm, diagnostic indicator
  • Wireless RF hall stations at each landing plus RF wireless key fob — no control wiring
  • Limit switches at each stop and final limit at the top
  • Honeywell residential car door interlock
  • Hatch cover with sensors and pressure-sensitive top safety device
  • Under-car safety pan — stops the car if an obstruction is encountered below
  • Slack cable safety device
  • Built to ASME A17.1 Section 5.3 residential elevator standards

Specifications

Everything your builder and installer will ask about — and everything we confirm in person at your free in-home assessment.

Model & entryEZ3 — front entry; smallest footprint in SHC’s EZ shaftless series
Car size33″W x 26″D x 76″H
Capacity400 lbs
Travel & stopsUp to 14′ between landings, 2 stops (shaftless); up to 3 stops and 21′ in-hoistway
Speed8-10 fpm (shaftless); 15 fpm in-hoistway
Drive systemDual winding cable drums, 1/4″ aircraft cables (7,000 lb breaking strength), 6063-grade aluminum track
PowerFull-time battery (two batteries, 2-amp smart charger); standard 120 VAC household outlet
Pit / machine roomNone required — new or existing construction
Rough floor opening38 3/4″ x 38″
Overhead clearance90″ minimum above top landing finished floor
StructureLoad-bearing wall required; static load 1,180 lbs; track fasteners at 6″ then every 30″
ControlsConstant pressure; wireless RF hall stations and key fob
Code complianceASME A17.1 Section 5.3 residential elevator standards
FinishRAL 9002 powder coat with clear vision panels; custom colors available

Configurations

How the doors open and where they sit on the cab — diagrams straight from the manufacturer’s planning materials. We confirm the right configuration for your floor plan at your in-home assessment.

Installation configurations

Shaftless through-the-floor

The standard install through a simple floor cutout: 2 stops and up to 14 feet of travel with constant-pressure controls.

In-hoistway with automatic controls

The same elevator inside a framed hoistway: press once and ride, with up to 3 stops and 21 feet of travel.

Entry configuration — diagrams

Front entry (standard) diagram

Front entry (standard)

Documents

Manufacturer brochures, owner’s manuals, and planning guides — yours to download.

Brochures & Product Guides

See the product, options and finishes at a glance — the best starting point for homeowners.

Owner’s Manuals & Care

How to operate and care for your unit day to day — for owners after installation.

Contractors

Working on the home? These are the technical documents your trades will ask for — electrical requirements, floor cut-outs, framing, and installation planning. Questions? Our licensed elevator mechanics are one call away at (316) 361-6220.

Planning Guides

The complete planning reference — dimensions, structural loads, electrical and code requirements. For builders and architects.

Electrical

Power requirements and wiring schematics — hand these to your electrician.

Site Prep & Requirements

What has to be ready before installation day — framing, door prep and support requirements for your GC.

Installation References

Factory installation instructions — how our certified crew installs it; helpful for contractors coordinating the job.

Optional upgrades

Ways to make this model fit your home and your routine even better. We price any of these into your written quote — just ask.

🏢

Optional upgradeIn-Hoistway Installation with Automatic Controls

The same EZ3 can be installed inside a framed hoistway and provided with automatic controls — press the button once and ride, with up to 3 stops and 21 feet of travel instead of the shaftless 2-stop, 14-foot limit.

🚪

Optional upgrade42″ Self-Closing Landing Gate

For balcony and mezzanine applications: a 42″-high self-closing landing gate with Honeywell residential interlock and acrylic clear vision panel. Right- or left-hand swing, easily switched in the field.

🛠

Optional upgradeSemi Free-Standing Package

When the ideal load-bearing wall isn’t available, the semi free-standing package anchors the elevator to the floor, upper floor joists, and ceiling instead.

🔑

Optional upgradeKey Switch on Hall Stations

Add a key switch to the wireless hall stations so you control exactly who can call the elevator — handy with grandkids in the house.

🎨

Optional upgradeCustom Colors

The standard finish is RAL 9002 gray-white, but SHC offers custom powder-coat colors so the elevator blends with your home — we’ve installed them in black and it looks sharp.

Two warranties on every install

You’re covered twice

Manufacturer warranty

Staying Home Corporation covers the EZ3 with a parts-only limited warranty to the original purchaser: the drive train is under warranty for 3 years (defined by SHC as the motor, gear, track, and steel cables), other parts for 2 years, and batteries for 1 year. Labor is not included in the manufacturer’s warranty — that’s exactly where our own workmanship warranty picks up.

Our workmanship warranty

Every installation also carries our 6-month workmanship warranty, on top of the manufacturer’s warranty. If our installation needs an adjustment, we come back and make it right at no cost to you. We ask clients to allow five to ten business days for a return trip, though it is often much sooner. The warranty covers our workmanship; it does not cover acts of God, user error, or misuse of the equipment.

Is the SHC EZ3 Home Elevator right for your home?

The only way to know is a free in-home assessment. We measure, we listen, and you get a straight answer with a written quote — no pressure.

Schedule Our Team Today Call (316) 361-6220
Call today Book online