Get Financing Design Yours Build Your Own

Residential Shafted Home Elevators

SHC EZ5 Home Elevator

The SHC EZ5 is the configuration flexer of Staying Home Corporation’s EZ series — the model to look at when a front-entry elevator just doesn’t suit your floor plan. It comes three ways: the EZ5 with pass-through double entry (ride in one side, roll out the other), the EZ5L with left-side entry, and the EZ5R with right-side entry. Like its EZ3 and EZ4 siblings, it’s a battery-powered home elevator that travels through a simple cutout in the floor — no elevator shaft, no pit, no machine room — carrying 400 pounds up to 14 feet between two landings. It runs full-time on its own two batteries, continuously charged from a standard 120-volt outlet, so it keeps working through a power outage with reserve for ten or more trips in both directions.

SHC EZ5 Home Elevator

The EZ5 was designed to retrofit into existing homes with minimal alterations. The integrated sliding door rides with the car, keeping you safely enclosed for the whole ride, and the traveling hatch floor covers the opening in the upper floor — finished to match your flooring, it disappears into the room when the car is parked below. Pressure-sensitive top and bottom safety devices stop the elevator if an obstruction is encountered, and a Honeywell residential door interlock, slack cable device, under-car safety pan, and emergency stop and alarm are all standard. Every EZ elevator is built to the ASME A17.1 Section 5.3 residential elevator standard, and like the rest of the series the EZ5 can also be installed inside a framed hoistway with automatic controls for up to 3 stops and 21 feet of travel.

Staying Home Corporation builds the EZ series in Harrisonville, Missouri — just south of Kansas City, right inside our service area — so factory support and parts are close by. Home Accessibility Solutions is a family-owned dealer, and our installers are licensed elevator mechanics with factory training; the photos on this page include EZ5 elevators our own team has installed. The same people who measure your home at the free consultation are the ones who install your elevator and service it for years afterward. Not sure whether your floor plan calls for front entry (EZ3, EZ4) or side/pass-through entry (EZ5)? That’s exactly what the free in-home assessment settles.

Model overview

Why choose the Staying Home EZ5 Elevator

The Staying Home EZ5 is a battery-powered home elevator that travels through a simple cutout in the floor — no elevator shaft, no pit, and no machine room. It carries 400 pounds up to 14 feet between two landings, and it runs full-time on its own two batteries, charged from a standard household outlet, so it keeps working through a power outage. What sets the EZ5 apart from its EZ3 and EZ4 siblings is its side and pass-through entry — it is the model to look at when a front-entry elevator does not suit your floor plan.

The EZ5 comes three ways: pass-through double entry, so you ride in one side and roll out the other; the EZ5L with left-side entry; and the EZ5R with right-side entry. It was designed to retrofit into existing homes with minimal alterations, and the traveling hatch floor can be finished to match your flooring, so it disappears into the room when the car is parked below. Need more than two stops? The same elevator can be installed inside a framed hoistway with automatic controls for up to 3 stops and 21 feet of travel. Custom powder-coat colors are available too.

Three ways to enter

The EZ3 and EZ4 are front-entry elevators. The EZ5 flexes: choose pass-through double entry to ride in one side and roll out the other, or a single left-side (EZ5L) or right-side (EZ5R) entry, each with a 25-inch car opening. That flexibility makes the EZ5 the model to look at when a front-entry elevator just does not suit your floor plan. See it on the manufacturer’s site →

Keeps running when the power goes out

The EZ5 runs full-time on its own two batteries, continuously charged by a 2-amp smart charger plugged into a standard 120-volt household outlet. During a power outage it keeps working, with reserve for ten or more trips in both directions.

No shaft, no pit, no machine room

The EZ5 travels through a simple cutout in the floor, so it retrofits into existing homes with minimal alterations. A traveling hatch floor covers the opening in the upper floor; finished to match your flooring, it disappears into the room when the car is parked below. There is no elevator shaft, no pit, and no machine room to build.

Safety at every point

The integrated sliding door rides with the car, keeping you safely enclosed for the whole ride. Pressure-sensitive top and bottom safety devices stop the elevator if an obstruction is encountered, and a Honeywell residential door interlock, slack cable device, under-car safety pan, and emergency stop and alarm are all standard. Every EZ elevator is built to the ASME A17.1 Section 5.3 residential elevator standard.

Room to grow with a hoistway

The standard shaftless install gives you 2 stops and up to 14 feet of travel with constant-pressure controls — you hold the button and ride. The same EZ5 can instead be installed inside a framed hoistway with automatic controls: press once and ride, with up to 3 stops and 21 feet of travel. We confirm which setup fits your home at the free assessment.

Two warranties, and a factory close by

Staying Home Corporation covers the EZ5 with a parts-only limited warranty to the original purchaser: 3 years on the drive train, 2 years on other parts, and 1 year on batteries. Every installation also carries our 6-month workmanship warranty — if our work was not done right, we come back and fix it at no cost to you, unless the issue was an act of God, user error, or misuse of the machine. And SHC builds the EZ series in Harrisonville, Missouri, so parts and factory support are close by.

Family-owned · Wichita, Kansas

From our family to your home

Working with us starts with a free in-home assessment: we measure, we listen, and you get a straight answer with a written quote — no pressure. Our installers are licensed elevator mechanics with factory training, and the same people who measure your home are the ones who install your elevator and service it for years afterward. Staying Home Corporation builds the EZ series in Harrisonville, Missouri — right inside our service area — so parts and factory support are close by. Call (316) 361-6220 to get started.

Schedule Our Team Today
Installed in a real home
Capacity400 lbs
TravelUp to 14 ft, 2 stops
Speed8–10 fpm (shaftless)
PowerBattery — 120 VAC outlet
CodeASME A17.1 Section 5.3
Warranty3 yr drive train (parts)

What comes standard

Included on every unit we install — no add-on cost.

Staying Home EZ5 Elevator

What comes standard

  • Choice of three entry configurations: EZ5 pass-through, EZ5L left-side, or EZ5R right-side
  • Integrated sliding car door with clear vision panels — rides with the car
  • Full-time battery power: two batteries with a 2-amp smart charger on a standard 120 VAC outlet
  • Runs 10+ trips in both directions during a power outage
  • Traveling hatch floor, finished to match your home’s floor coverings
  • Fold-down seat
  • Slimline telephone inside the car
  • Carpet on the car floor and floor cutout liner kit
  • RAL 9002 powder-coated finish
  • Constant pressure controls: up/down buttons, key switch, emergency stop, alarm, diagnostic indicator
  • Wireless RF hall stations at each landing plus wireless key fob — no control wiring required
  • Limit switches at each stop and final limit at the top
  • Honeywell residential car door interlock
  • Hatch cover with sensors and pressure-sensitive top safety device
  • Under-car safety pan and slack cable safety device
  • Built to ASME A17.1 Section 5.3 residential elevator standards

Specifications

Everything your builder and installer will ask about — and everything we confirm in person at your free in-home assessment.

Entry optionsEZ5 pass-through double entry; EZ5L left-side; EZ5R right-side — 25" car opening per side
Car footprint33"W x 39"D nominal, 76" car height
Capacity400 lbs
Travel & stopsUp to 14′ between landings, 2 stops (shaftless); up to 3 stops and 21′ in-hoistway
Speed8-10 fpm shaftless; 15 fpm in-hoistway
Drive systemDual winding cable drums with 1/4" aircraft cables (7,000 lb breaking strength) on extruded 6063-grade aluminum track
PowerTwo batteries, 2-amp smart charger; standard 120 VAC outlet — operates during power outages
Pit / machine roomNone required — new or existing construction with minimal alterations
Rough floor opening46 1/4" x 45 1/2" — works with perpendicular or parallel floor joists
Overhead clearance90" above the top landing finished floor
StructureLoad-bearing wall required; static load 1,180 lbs; track fasteners at 6" from bottom floor and every 30" above
Code complianceBuilt to meet ASME A17.1 Section 5.3 residential elevator standards
FinishRAL 9002 powder coat with clear vision panels; carpeted car floor; custom colors available

Configurations

How the doors open and where they sit on the cab — diagrams straight from the manufacturer’s planning materials. We confirm the right configuration for your floor plan at your in-home assessment.

Entry configurations

EZ5 - pass-through double entry diagram

EZ5 – pass-through double entry

Ride in one side and roll out the other, with a 25-inch car opening on each side.

EZ5L - left-side entry diagram

EZ5L – left-side entry

A single entry on the left side of the car.

EZ5R - right-side entry diagram

EZ5R – right-side entry

A single entry on the right side of the car.

Installation configurations

Shaftless through-the-floor

The standard install through a simple floor cutout: 2 stops and up to 14 feet of travel with constant-pressure controls.

In-hoistway with automatic controls

The same elevator inside a framed hoistway: press once and ride, with up to 3 stops and 21 feet of travel.

Documents

Manufacturer brochures, owner’s manuals, and planning guides — yours to download.

Brochures & Product Guides

See the product, options and finishes at a glance — the best starting point for homeowners.

Owner’s Manuals & Care

How to operate and care for your unit day to day — for owners after installation.

Contractors

Working on the home? These are the technical documents your trades will ask for — electrical requirements, floor cut-outs, framing, and installation planning. Questions? Our licensed elevator mechanics are one call away at (316) 361-6220.

Planning Guides

The complete planning reference — dimensions, structural loads, electrical and code requirements. For builders and architects.

Electrical

Power requirements and wiring schematics — hand these to your electrician.

Site Prep & Requirements

What has to be ready before installation day — framing, door prep and support requirements for your GC.

Installation References

Factory installation instructions — how our certified crew installs it; helpful for contractors coordinating the job.

Optional upgrades

Ways to make this model fit your home and your routine even better. We price any of these into your written quote — just ask.

🏢

Optional upgradeIn-Hoistway Installation with Automatic Controls

The same EZ5 can be installed inside a framed hoistway and provided with automatic controls — press the button once and ride, with up to 3 stops and 21 feet of travel instead of the shaftless 2-stop, 14-foot limit.

🚪

Optional upgrade42″ Self-Closing Landing Gate

For balcony and mezzanine applications: a 42″-high self-closing landing gate with Honeywell residential interlock and acrylic clear vision panel. Right- or left-hand swing, easily switched in the field.

🛠

Optional upgradeSemi Free-Standing Package

When the ideal load-bearing wall isn’t available, the semi free-standing package anchors the elevator to the floor, upper floor joists, and ceiling instead.

🔑

Optional upgradeKey Switch on Hall Stations

Add a key switch to the wireless hall stations so you control exactly who can call the elevator — handy with grandkids in the house.

🎨

Optional upgradeCustom Colors

The standard finish is RAL 9002 gray-white, but SHC offers custom powder-coat colors so the elevator blends with your home — we’ve installed them in black and it looks sharp.

Two warranties on every install

You’re covered twice

Manufacturer warranty

Staying Home Corporation covers the EZ5 with a parts-only limited warranty to the original purchaser: the drive train is under warranty for 3 years (defined by SHC as the motor, gear, track, and steel cables), other parts for 2 years, and batteries for 1 year. Labor is not included in the manufacturer’s warranty — that’s exactly where our own workmanship warranty picks up.

Our workmanship warranty

Every installation also carries our 6-month workmanship warranty, on top of the manufacturer’s warranty. If our installation needs an adjustment, we come back and make it right at no cost to you. We ask clients to allow five to ten business days for a return trip, though it is often much sooner. The warranty covers our workmanship; it does not cover acts of God, user error, or misuse of the equipment.

Is the SHC EZ5 Home Elevator right for your home?

The only way to know is a free in-home assessment. We measure, we listen, and you get a straight answer with a written quote — no pressure.

Schedule Our Team Today Call (316) 361-6220
Call today Book online